Skip to main content

IND12-OLED indication

IND12-OLED shows battery status on a monochrome 128 × 64 pixel display.

Display readings​

In normal mode, a 10-segment battery bar occupies the upper half of the screen. The number of filled segments follows SOC rounded up to the nearest 10%; at 0% the bar is empty.

The lower half shows:

FieldReading
Upper left, %Battery state of charge (SOC)
Upper right, VBattery voltage
Lower left, ASigned battery current
Lower right, min / max, CMinimum and maximum temperatures reported by the BMS, °C

Unavailable values are replaced with ---. Voltage and current below 100 in magnitude use one decimal place; values of 100 and above are rounded to whole units.

Indication modes​

At start-up, the firmware may briefly show a logo. A waiting animation appears until BMS data arrives and when the connection is lost.

StateIndicationExample
Start-up or no BMS connectionA ring of dots with a moving highlight.IND12-OLED waiting for BMS
NormalBattery bar and numeric readings.IND12-OLED normal SOC
Charger connectedSame as Normal if charging has not started and there are no other warnings.IND12-OLED charger connected
ChargingA dithered segment moves from the right end of the bar towards the current charge level. Label: “Charging”.IND12-OLED charging
BalancingA highlighted segment moves back and forth along the bar. Label: “Balancing”.IND12-OLED balancing
Low SOCFilled segments blink; the battery outline stays visible. Label: “Low charge”.IND12-OLED low SOC
Very low SOCDithered segments blink; the battery outline stays visible. Label: “Very low charge”.IND12-OLED very low SOC
Deep dischargeThe empty battery outline blinks. Label: “Battery empty”.IND12-OLED empty battery
FaultA filled triangle with an exclamation mark. Label: “Fault”.IND12-OLED fault
Pre-faultAn outline triangle with an exclamation mark. Label: “Pre-fault”.IND12-OLED pre-fault
Post-faultAn outline triangle with an exclamation mark. Label: “Post-fault”.IND12-OLED post-fault
Over-temperatureAn outline triangle with a heat symbol. Label: “High temp.”.IND12-OLED over-temperature
Under-temperatureAn outline triangle with a snowflake. Label: “Low temp.”.IND12-OLED under-temperature
Over-voltageAn outline triangle with a lightning bolt. Label: “Over voltage”.IND12-OLED over-voltage
Under-voltageAn outline triangle with a battery and a downward arrow. Label: “Low voltage”.IND12-OLED under-voltage
Over-currentAn outline triangle with a plug and a lightning bolt. Label: “Over current”.IND12-OLED over-current

Sound​

BMS eventSound
Normal, charging or balancing without warningsSilent
Low SOCOne short beep about every 3 minutes
Very low SOC or deep dischargeThree short beeps about every minute
Fault, pre-fault, post-fault, over-temperature, under-temperature, over-voltage, under-voltage or over-currentFrequent short beeps, about once per second